How To: Add / Remove Features from a Trust Protection Platform Installation

Applies To:

All Versions of Director 6.1.2 and above, Trust Protection Platform 14 and above 14

Subject:

Occasionally the Trust Protection Platform installation needs to be amended so features such as the Aperture portal, WebSDK are added or removed.

This article describes how to perform this task.

Instructions:

Steps to add / remove features are version dependent. Refer to the correct section for your version.

If you do not know which version is installed, check this Knowledge Base article

NOTE: To perform these steps, the below is required:

A user with local administrator privileges

Credentials for a Venafi Encryption Director or Venafi Trust Protection Platform local master admin

Venafi Encryption Director 6.x to 11.x

Open a Command Prompt as an Administrator
Go to the directory where Venafi Encryption Director is installed. By default C:\Program Files\Venafi\Platform
Type the command: DCC.exe -wizard
The Configuration Wizard should appear
At the Select Product page, add / remove products as required on this particular server
At the Component Selection page, add / remove components as required
Complete the wizard

Venafi Trust Protection Platform 14.1 to 14.3

Go to Start > Programs > Venafi
Right click and run Venafi Control Center as an Administrator
Select Install or upgrade database
At the Select Product page, add / remove products as required on this particular server
At the Component Selection page, add / remove components as required
Complete the wizard

Venafi Trust Protection Platform 14.4 and above

Go to Start > Programs > Venafi
Right click and run Venafi Control Center as an Administrator
Select Configure Products
At the Select Product page, add / remove products as required on this particular server
At the Component Selection page, add / remove components as required
Complete the wizard

How To: Check the current Director version and installed patches